Welcome to the official website of Hebei Zhengsai Metal Products Co., Ltd

Factors affecting punching mesh boards

Time:

2022-10-09 10:14

When choosing a punching mesh, try to consider demand, application and product costs at the same time as consumers. For example, if you want to reduce the thickness of the punch mesh board, you can only use a slightly higher alloy as a material. The stiffness and intensity of the punching mesh also directly determines the size and arrangement of the hole. You should know that ordinary boards are easier to accept than special requirements. PVC sheet and various composite materials. Pole mesh plate thin plates are more prone to stamping and lower costs.

 

Under the premise of meeting the principle of the pores of the punching mesh, proper plate thickness is more conducive to improving the pressure resistance of the product, and the board has a certain tolerance. The thickness of the board we can suppress is between 0.1mm and 25mm. The general board specifications are 1000mm*2000mm and 1000mm*nm coil. 

Pores:

Generally speaking, the aperture should be greater than or equal to the thickness of the plate, that is, the principle of the minimum pore diameter should be met. The closer to the pores you require, the greater the processing difficulty and the higher the processing cost. In some materials, the hole may be smaller than the thickness of the board. We can do a 0.08mm hole diameter

The distance between the center is the center of the hole and the center of the hole closest. The central distance is one way to indicate the pore spacing, and the other is the pore diameter ratio. These two expressions are basically the same meaning.

The pore rate is the ratio of the total area of ​​the pore area to the plate, which can be represented by percentage. Users should realize that the pressure of the stamping device will cause the plate to deform. Generally speaking, the larger the opening rate, the more obvious the deformation of the plate, especially when there is no corners of the four horns. This deformation can be flattened with a special machine in our workshop, so you also need to consider the special requirements and ask us carefully.

The blank is a area where there is no perforation at the edge of the board, and the typical punching mesh has a long side that needs to be left. If you have special requirements, you need to provide the manufacturers with four sizes. The edge may be affected by manufacturing. If the customer's requirements are not met, the manufacturer will provide similar products with the customer's consent.

In the actual production and application process, there are all aspects that affect the quality factors that affect the punching mesh. If you want to buy a suitable punching mesh, you will not only discuss with the manufacturer before buying, and check it multiple times. When you get the product, you It is also necessary to test and maintain and maintain during use. In this way, it is not easy to cause damage during the process of using the product in the later stage, which greatly extends the service life of the punching mesh. This is also an economic practice.

Punching mesh