The processing method of the punching mesh refers to the holes of different shapes on the same material to meet different requirements. It can be used as a noise management barrier in transportation municipal equipment through the urban highway, railway, and subway. It can also be used as sound insulation and sound -absorbing board for noise sources such as building walls, generators, and factory buildings.

There are many ways to process the punching mesh. The commonly used stamping method is a single rush, that is, the stamping is completed at one time. According to the type and distribution method of the holes, the punching mesh can be divided into: straight line distribution, circular distribution, circular distribution, grid hole punching hole, punching mesh.

Continuous feeding: long holes processing, cutting edges, etc. It can be stopped by partial stacking rectangular molds; continuous ruling in multiple directions: processing large holes with small molds. Metal mesh tailor: Use a small round mold to stop the continuous arc punch process at a small step.

The formation method of punching mesh: Single molding: One step according to the shape of the mold, continuous molding: molding is greater than the mold size of the mold, such as large -sized shutters, roll tendons, and rolling steps. Formation: Make multiple same or different workpieces on a large plate.

The climbing perforated mesh is made of metal plates. The surface spray is very strong and durable, not afraid of wind and rain. However, due to the long -term rain forests and sun exposure, most of the materials of plastic products have been aging and cannot be used again. Some of them need to be replaced halfway, causing a lot of cost waste to merchants. The purpose of climbing the reinforcement mesh: It can be fully closed for various construction sites, especially high -rise buildings. It can effectively prevent people and objects from falling, prevent fire caused by welding sparks, reduce noise and dust pollution, and achieve the effects of civilized construction, environmental protection and beautifying cities.

There are many steel structures between the punching mesh and the building, otherwise the rectangular tube on the punching grid of the climbing rack is not available in any fixed and enhanced effect. The main purpose is to make the climbing rack and surface punching mesh smoothly fixing and supporting it on the frame without falling off. In the improvement operation, the improvement is also carried out by adjusting the internal steel frame structure. This seems to be climbing as a whole. The surface climbing rack punching steel plate net continues to improve with its internal structure.

The climbing racks are connected to the climbing rack. The installation of the climbing rack punching mesh should generally be carried out from the bottom up. Each climbing punching mesh board requires correct positions, smooth surfaces, tight joints, and strict seams. The U -shaped card on the same seam should be set in front of the same direction to prevent the overall deformation of the steel mesh. After the installation is completed, check whether it is firm one by one to prevent accidents from being installed.

The above are some knowledge points about the punching network board. I hope that you can learn about relevant knowledge carefully, and choose the products and equipment suitable for your own needs to ensure your own benefits. If you want to know more details, you can contact us. I believe Give you a satisfactory answer.